Skip to content

Configuring Initial Setup Parameters

Before you use your Tera2 PCoIP Zero Client for the first time, you need to configure initial setup parameters, including setting basic audio, network, and session information.

You can perform this initial setup from the AWI Initial Setup page, shown next.

Alt text
AWI Initial Setup page

The following parameters display on the AWI Initial Setup page:

Audio Parameters

Category Parameter Description
Audio Enable HD Audio Enables audio support on the client
Network Enable DHCP Enables DHCP (as opposed to using manual IP address configuration)
IP Address Device’s IP address
Subnet Mask Device’s subnet mask
Gateway Device’s gateway IP address
Primary DNS Server Device’s primary DNS IP address
Secondary DNS Server Device’s secondary DNS IP address

You can also configure network settings from the OSD and AWI Network and Audio pages

You can configure the initial setup settings, as well as other network settings, from the OSD and AWI Network pages. To configure network settings from these pages, see Configuring Audio and Configuring Network Settings.

Session Parameters

Session parameters are configured from the AWI Configuration -> Session page.

To configure initial setup parameters from the AWI:

  1. From the AWI, select Configuration > Initial Setup.

  2. From the AWI Initial Setup page, configure audio, and network parameters.

  3. Browse to Configuration > Session and select your preferred session type.

  4. Click Apply to save your configuration.