Skip to content

Connecting the Tera2 PCoIP Zero Client to the NetworkΒΆ

To connect the Tera2 PCoIP Zero Client:

  1. Connect a USB keyboard and mouse to any of the Tera2 PCoIP Zero Client USB ports.

  2. Connect one end of the Ethernet cable to the Tera2 PCoIP Zero Client and the other end to a switch/router. The switch or router should be on the same network as the Remote Workstation Card or virtual desktop server if there is not a PCoIP Management Console that is managing the PCoIP endpoints.

  3. Connect monitor cables to the Tera2 PCoIP Zero Client.

    Connect monitors using correct ports

    To ensure the best experience, connect monitors to the zero client ports in sequential order

    Supporting 2560 x 1600 resolutions

    Ensure your cables are connected as shown when configuring monitors for 2560 x 1600 resolutions. For more information see knowledge base article 1025

    Dual Port Zero Client
    Single Display at 2560 x 1600 Resolution

    Dual High Resolution Monitors
    Dual Displays at 2560 x 1600 Resolutions

    Connecting to Remote Workstation Cards

    For additional information when connecting monitor cables using PCoIP Remote Workstation Cards, refer to the Remote Workstation Card Administrators' Guide - Installation section

  4. (Optional) Connect speakers and/or headphones to the Tera2 PCoIP Zero Client.

  5. Connect the power supply to the Tera2 PCoIP Zero Client and a power source.

  6. Press the front panel button to power on the Tera2 PCoIP Zero Client.